Pneumatic Body Contouring System — Complete Set

A complete pneumatic body contouring system for Slim Belly users. Control unit, two air tubes and two TPU belts on the same two-nozzle connection, so belts and units can be interchanged.

A complete pneumatic body contouring set: control unit, two air tubes and two belts.

The control unit drives air into chambers built into the belt. The chambers are arranged in two alternating groups, so while one group is inflating the other is releasing. That alternation is what produces the working pressure on the abdominal area — it is not a single static squeeze.

How one pressure cycle runs

One cycle takes up to 80 seconds (about 60 seconds in normal operation). Each of the two air channels follows the same sequence:

• 20 seconds — inflation, until the chamber reaches the 320 mmHg threshold (or 20 seconds elapse, whichever comes first)
• 15 seconds — pressure held on the belt
• 5 seconds — release

The two channels run out of phase, so the belt is never working as one solid band.

Technical specifications

Built-in diagnostics

The control unit checks itself on start-up and keeps monitoring while running:

• Battery — one beep means ready; two beeps mean low (5.8–6.3 V) but still working; three beeps mean exhausted (below 5.8 V) and the unit goes to standby until charged
• Leak detection — a serious leak across two consecutive cycles forces the unit into standby
• Over-temperature — shutdown at 50°C or above
• Over-current — shutdown at 3 A or above

What is in the set

• Control unit × 1
• Air tubes × 2
• Belt, small × 1
• Belt, large × 1
• Power adapter × 1

DualAirPressure: two chamber groups, working against each other

The belt holds two separate sets of air chambers. Group A — about 12 to 16 chambers — inflates while group B, also about 12 to 16 chambers, releases. Then the two swap.

That is the whole idea behind the name. Because the groups work alternately and out of phase, the same area of the abdomen is compressed, released and compressed again through the cycle, rather than being held under one constant squeeze. Single-group belts cannot do this: with one set of chambers, the belt can only inflate and deflate as a whole.

Professional version vs home version

Two internal parts decide how long a unit will last in service, and both differ between the two versions.

The valves are a rubber component and wear with every cycle, which makes them the part that limits how long a unit can run in daily service. That is why the professional version uses a different valve specification rather than the same parts as the home version.

Ordering

Available for wholesale and private-label programmes from our own factory. Belt sizing, control-unit labelling and packaging can all be specified per order. Contact us for MOQ, lead time and certification documents.

This is a wellness and fitness device, not a medical device. It is not intended to diagnose, treat or cure any condition.

Full technical answers — cycle timing, motor and valve life, belt sizes, spare parts: read the technical FAQ.

Slim Belly is a registered trademark of Airpressure Bodyforming GmbH & Co. KG. We are an independent manufacturer and are not affiliated with, endorsed by or authorised by the trademark owner.